How to Replace the Cycling Thermostat on a GE Model GUD27ESSJOWW
Replacing the cycling thermostat on your GE Model GUD27ESSJOWW refrigerator is a task that can be tackled by most homeowners with a bit of patience and the right tools. This guide will walk you through the process step by step, ensuring that you can get your fridge up and running smoothly again.
Tools and Materials Needed
Before you begin, gather the following tools and materials:
- Flat-head screwdriver
- Phillips-head screwdriver
- Replacement cycling thermostat
- Antistatic wrist strap (optional)
Step 1: Unplug the Refrigerator
Always start by unplugging the refrigerator from the electrical outlet to ensure your safety. This is a crucial step that should not be overlooked.
Step 2: Remove the Rear Panel
Locate the screws holding the rear panel in place. There are typically two or three screws, depending on the model. Use a flat-head screwdriver to remove them and set them aside. Carefully pull the rear panel away from the refrigerator to expose the cycling thermostat.
Step 3: Disconnect the Cycling Thermostat
The cycling thermostat is usually connected to the compressor with two wires. Use a flat-head screwdriver to gently disconnect the wires from the thermostat. Be sure to note the wire connections so you can reconnect them correctly later.
Step 4: Remove the Old Cycling Thermostat
With the wires disconnected, you can now remove the old cycling thermostat. It may be held in place by clips or screws. Use your hands to gently pull it out of its housing.
Step 5: Install the New Cycling Thermostat
Take the new cycling thermostat and insert it into the housing. Make sure it is properly seated and secure. If there are clips, clip them into place. If there are screws, use a Phillips-head screwdriver to tighten them.
Step 6: Reconnect the Wires
Reconnect the wires to the new cycling thermostat. Be sure to match the wires to the correct terminals, as indicated by the color coding. If you took notes earlier, refer to them now to ensure proper connections.
Step 7: Reattach the Rear Panel
With the new cycling thermostat installed and the wires securely connected, you can now reattach the rear panel. Replace the screws you removed earlier and tighten them to secure the panel in place.
Step 8: Plug in the Refrigerator
Once the rear panel is securely in place, plug the refrigerator back into the electrical outlet. Turn it on and check to see if it is functioning properly. The cycling thermostat should now be working, and your refrigerator should be cooling as it should.
Step 9: Test the Refrigerator
Let the refrigerator run for a few hours to ensure that it is cooling properly. Check the temperature settings and make sure the fridge is maintaining the desired temperature. If everything seems to be working correctly, you have successfully replaced the cycling thermostat on your GE Model GUD27ESSJOWW refrigerator.
Precautions and Tips
Here are a few precautions and tips to keep in mind during the replacement process:
- Always unplug the refrigerator before beginning any repair work.
- Be careful when handling the wires to avoid damaging them.
- Make sure the new cycling thermostat is compatible with your refrigerator model.
- Keep the replacement thermostat in a cool, dry place until you are ready to install it.
By following these steps and precautions, you should be able to replace the cycling thermostat on your GE Model GUD27ESSJOWW refrigerator with ease. If you encounter any difficulties or are unsure about any step, it is always best to consult a professional technician.
